![]() ![]() Use the Home button to exit the System Test.Press to turn stages on one at a time, and press to turn them off.Use to change between Heat, Cool, Fan, Em Heat, or Ver (thermostat version information).NOTE: A complete list of all setup (ISU) parameters and options starts below and continues through page 10. To finish setup process and save your setting, press Home and return to Home screen.Press Select and confirm your settings or press Back to ignore changes and return to ISU menu screen to continue editing another setup option.Press or to change values or select from available options.Press Select to cycle through menu setup options.Press and hold CENTER and buttons for approximately 3 seconds to enter advanced menu.Circ: Fan runs randomly about 33% of the time.Auto: Fan runs only when the heating or cooling system is on.NOTE: Available Fan modes vary with system settings. Cycle through the modes until the required Fan mode is displayed and leave it to activate.Press the Fan button to cycle to the next available Fan mode.NOTE: Available System modes vary by model and system settings. It might be a flashing light, a battery symbol, or text stating the warning what matters is that you do not ignore it. Almost all programmable models have a low battery indicator appears, usually around a month or two before the battery runs out entirely. Cycle through the modes until the required System mode is displayed and leave it to activate. When your thermostat tells you the batteries are about to die, it's time for some new ones.Press the Mode button to cycle to the next available System mode.Turn the power on at the breaker box or switch. While a ‘Replace bat’ message always sounds the alarm when your thermostat runs low on batteries, a wise move would be to change them periodically nonetheless.Align the UWP with the thermostat, and push gently until the thermostat snaps in place.Push excess wire back into the wall opening.NOTE: Slider Tabs for U terminals should be left in place for T6 Pro models. If there is one wire connected to the R terminal and one wire connected to the Rc terminal, set the slider to the down position (2 wires).If there is only one R wire, and it is connected to the R, Rc, or RH terminal, set the slider to the up position ( 1 wire).Use built-in jumper ( R Slider Tab) to differentiate between one or two transformer systems.Insert and tighten mounting screws supplied with the UWP. Pull the door open and insert the wires through wiring hole of the UWP.See Figure 6.ĭrill holes at marked positions, and then lightly tap supplied wall anchors into the wall using a hammer. Before starting, turn the power off at the breaker box or switch.Snap the Cover Plate onto the Junction Box Adapter.Attach the UWP by hanging it on the top hook of the Junction Box Adapter and then snapping the bottom of the UWP in place.Insert and tighten mounting screws supplied with Cover Plate Kit. Mount the Junction Box Adapter to the wall or an electrical box using any of the eight screw holes.Separate the Junction Box Adapter from the Cover Plate.Or when you need to cover paint gap from old thermostat.Mounting the thermostat to an electrical junction box.Have a wonderful day and feel free to respond if this does not solve your problem. It mentions if this doesn't work, that the Thermostat is malfunctioning. Other type of batteries, such as rechargeable or lithium batteries will not work properly in the thermostat. Make sure that you are using alkaline batteries on your thermostat. If your thermostat does not light up after this procedure, you might have a defective thermostat. Your thermostat should reboot and the LOW BAT message should be deleted. Remove the batteries and place them back to the correct position. Leave the batteries like that for 30 seconds. Remove the batteries from the thermostat and place them in the opposite / wrong / incorrect position in the thermostat place the (+) on the (-) and vice versa). ![]() These are the steps to resetting the Lo Bat display that pops up:ġ. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |